In short: the dew point is the temperature to which the air must be cooled to saturation with an unchanged water vapor content. If the leaf or other surface reaches this temperature, water may precipitate on it. The difference between air temperature and dew point is therefore a more important practical signal than either value alone.

Nocturnal wettingThe difference between the cooling of the air and the dew point is the key
Daytime statusAir temperature above the dew point
Cooling downThe plant surface loses heat quickly
SaturationThe surface reaches the dew point
CondensationDew and wet foliage develop
The dew point is a reference point, but the actual wetting is determined by the temperature of the leaf and the local microclimate.

Dew point and relative humidity

Relative humidity expresses how close the air is to saturation at the current temperature. When the same air cools, the relative humidity rises; if heated, it can decrease without giving off water vapor. That is why it can be cool in the morning at 95 percent, and in the afternoon the relative humidity is much lower.

The dew point follows this mere temperature change less and gives a more direct picture of the water vapor content of the air. If the air temperature is 18 °C and the dew point is 17 °C, saturation is close. If the dew point is 5 °C at the same 18 °C, the air is much drier.

dew point difference = air temperature − dew point

Why can the leaf be dewy when the humidity is below 100%?

Meteorological temperature and humidity are typically measured in the air, but the surface of the leaf follows its own energy balance. On a clear, weak windy night, it quickly loses heat through long-wave radiation, so it can be colder than the surrounding air. The leaf can already reach the dew point even when the air at the measuring height is still slightly warmer and the relative humidity does not show exactly 100 percent.

Wind, temperature and humidity can be different inside the dense stand than at the edge of the field or at a height of two meters. Cool air gathering in the deeper areas can increase the difference. This microclimate is the reason why dew does not start and end on the same field at the same time.

What does the dew point say about nighttime cooling?

The latent heat released during condensation can slow down further cooling, so the dew point is a useful reference for nighttime temperature changes. However, it cannot be considered a guaranteed minimum. If drier air arrives, the wind changes or the clouds break up, the dew point and expected minimum may also change.

In frosty conditions, the dew point of the air, the temperature of the plant surface and the frost point of the ice must be treated separately. A ground frost the topography, wind, cloudiness, soil heat storage and plant sensitivity are also necessary for its risk. Frost protection irrigation should not be started based on a single dew point value.

Relationship with leaf wetness and crop protection

When the plant surface reaches the dew point, wetting can begin. The risk of infection then depends on how long the foliage stays wet and what temperature prevails during that time. This is detailed in guide on leaf wetness explains.

Dew can also influence the spraying decision. On wet foliage, the spray juice may dilute or run off, and with other products, specific moisture conditions may be required. The license document and the label always come first; the weather control sequence is a article on spray window sum up.

Practical evening checklist

  • Look at the current difference in air temperature and dew point, and then its nightly trend.
  • Pay attention to clouds and wind: they have a decisive influence on the radiative cooling of the surface.
  • Identify depressions, wind-sheltered and dense stands.
  • Evaluate not only the onset of dew, but also the expected drying time the next day.
  • In the absence of a local sensor, treat the result of the model as an estimate and occasionally check it in the field.
Important difference: a high dew point indicates a lot of moisture in the air, but for dew to form, the plant surface must also cool down to the saturation temperature.

FAQ

What does it mean when the temperature reaches the dew point?

The air becomes saturated with the given water vapor content. If a plant surface also cools to this temperature or below, condensation may start on it, i.e. dew may form.

Does the dew point show the overnight minimum?

It gives an indication of the moisture content of the air and the onset of condensation, but not a hard lower temperature limit. The minimum may differ due to inflow of drier air, wind, clouds and topography.

What is the difference between dew point and relative humidity?

The relative humidity is strongly dependent on the current temperature. The dew point more directly indicates the actual water vapor content of the air: the higher it is, the more moisture there is in the air.

Sources

The relationship between dew point and relative humidity is American National Weather Service explanation sum up. About the surface processes of the formation of dew and frost a NWS educational material gives more details.